SK Enterprises Mfg LLC
High Performance Pet Products
U-FILL-IT
BEDS
DURA
CRATE
BEDS
CUSTOM
SIZED
BEDS
CONTACT US
Products
ORDERING
RETURNS
PRIVACY
ABOUT CORDURA
FAQ'S
ABOUT US
HOW TO PAY US
CUSTOMER
PICTURES
HOW WE SHIP
DURA-BEDS
SITE MAP
PLASTIC
CRATE
BEDS
Form a loop with
the left hand tie leg.
INSTALLING YOUR PLASTIC CRATE BED
Start to form an overhand knot by bringing the loop around and behind itself like this.
Form a small hole in the center of the loop.
Bring the end of the loop through the center of the hole, and pull tight like this. You should have about 1" through the center after finishing.
PAGE ONE
PAGE TWO
PAGE THREE
FINAL STEPS!
Start pulling tight.
Then hold the loop and other tie leg so it doesn't slip back.
While holding the left loop tight, bring the other tie leg around itself like this and form another loop.
Then bring the end of this tie through its loop, and pull tight.
The finished knot should look similar
to this.
Repeat steps A and B above twice, pulling tight each time.
This secures the knot from slipping.
A
B
Continue around the crate, tying each tie as in the previous steps.
You are finished with the bed tying!
Your crate should now look similar to this one.
Here is the installed bed.
Re-assemble your crate and you are ready to go.
This shows a view of the installed bed, and
the ties around the bottom edge of the crate.
You are done, good job!
PAGE ONE
PAGE TWO
